I was walking near the government of Canada building on Yonge Street when the grass was still green and found this: A completely torn drainage mat. But is this really a serious problem other than an eyesore?
The installers of this waterproofing drainage mat layer secured the flashing termination with concrete screws.
To achieve a nice clean look the termination strip plastic flashing flashing was installed correctly, but er…. someone forgot to fasten the mat below grade with clips.
Instinct may tell you not to poke holes in your new drainage mat below grade, but with a self adhereing membrane underneath, the nails are self sealing. If you you are still concerned, a sealant can be applied around the fastener, but I don’t think it is necessary.
Here is the correct way to support the drainage mat, as shown below. The termination strip has not been installed yet in that picture.
The location of the clips are not critical. It is a good idea to try to not install one directly below a window ledge flashing termination where more water may accumulate.
So does this mean that the installation with the black mat at the top of the page will do harm? Well maybe to the eyes, yes. It depends if there are any fasteners below grade, because those will have ripped too, creating a hole in the mat. But even then, how much water would enter that tear? Keep in mind that the mat covers a large surface area. Another question to ask is how far does the mat slip down? Does it slip down enough to interfere with the weeping tile system? That is a big maybe. It depends on how much settling is taking place.
How did this happen and what could be done?
The soil and/or gravel backfill does settle, and it is the job of the installers to compact the soil with hand tampers every 1 foot or so. When settling occurs, the mat is pulled down with it, and if there is enough support (using the clips), the soil will settle, but the forces wont be strong enough to tear the mat. The soil would then slide down beside the mat instead of tearing it. There will always be settling, but if there if the soil and gravel was tamped well, then the above scenario may not be a concern at all. Resetting the height of the termination strip may eliminate the eyesore if the mat stops settling.
- Always support the map with clips below grade and don’t rely on the termination strip for support
- If you are concerned about settling, make a small mark on the wall every 6 months, and see if the settling begins to stop